What you need:
- 30k Ohm potentiometer/trimmer
- Soldering equipment
- Cables, something to insulate
vRimm Mod
Here you can see the HIP6521, the vRimm Control Chip (the Datasheet is here)
The chip is rotated by 180° on the board
Solder the poti between FB and Ground (GND). Using the ground from the chip is a good idea, but it's not required - any ground will work
Set the 30k Ohm pot to the maximum of 30k Ohm. Lower the resistance for higher voltage.
Above 3 Volt vRimm the board's monitoring stops working (fixed with the new BIOS), but I think that's enough.
The theoretical maximum should be ~4,5 Volt.
0 comment on "Abit TH7II(-Raid) Voltmods"
Post a Comment