GeForce GTX 285 Voltmods

Introduction

This voltmod applies to all GeForce GTX 285 cards using the NVIDIA reference PCB.

Disclaimer:
Performing these voltmods will void any and all warranties your video card may have.
You - and only you - are responsible for any damage caused indirectly (or directly) by these modifications.

Overview

GPU Voltage Mod (soldering)

1. Remove the little 0 Ohm resistor before soldering on the wires.
2. Solder wires.
3. Make sure the trimmer is set to 0 Ohms of resistance between the pads where the 0 Ohm resistor was.
4. Slowly turn up the resistance to increase the voltage.

A pencil VDDC mod is not available at this time.

GPU Overvoltage Protection Mod (soldering)

-->read more...